Do previous Hypershell X Series products support end-to-end control? Can they support it through an upgrade?Updated 3 hours ago
No. Previous Hypershell X Series products do not support end-to-end control, and this cannot be enabled through a firmware upgrade.
End-to-end control requires the support of a next-generation hardware platform, including stronger on-device computing capability and system architecture, to meet the real-time motion-control requirements of HyperIntuition.
Previous X Series products will continue to support their existing MotionEngine capabilities, while E-to-E end-to-end control is only available on the new Hypershell X Series.